This tapping fitting is a consumable part with a completed blocking tee, which is used to weld on pipelines   for branch connection. Its lower end arc is the diameter size of the pipeline, and there is a bypass interface at the neck to connect the bypass pipeline. The inner and size can be determined according to customer requirements.

Balanced pressure tee is a type of consumable part with completed blockage, which is welded to the pipeline to provide a fixed seat for wafer valves and hot tapping machines or plugging machines. It is equipped with plug, which is installed in the flange to cut off the medium after the operation is completed, making it easy to remove the wafer valve. The internal structure has two forms of pins and locking blocks to tighten the blockage.

This PE valve is mainly used as a common component for PE pipe hot tapping and plugging. During construction operations, the opening and plugging equipment is replaced by the gate valve opening and closing function of the fan valve.

This PE valve is mainly used as a common component for PE pipe hot tapping and plugging. During construction operations, the opening and plugging equipment is replaced by the gate valve opening and closing function of the fan valve.

This pipe fitting is a consumable part for PE pipes with tees. It mainly consists of a pipe cap, saddle tee, lower support plate, blocking and plugging device, connecting pressure plate, fastening bolts, etc.

PE pipe fittings are consumables. It consists of protective cap, upper saddle, lower support plate, blocking sealing device, connecting pressure plate, fixing bolt and other components.

The TPP hydraulic station is a device specifically designed to provide power sources for hot tapping machines and plugging machines. Due to the special nature of the assignment, the motor used is an explosion-proof motor.

The wafer valve is designed for use with Taitat Changlin Tapping, Plugging Machines, and fittings during hot tapping and plugging (HT&P) operations. Wafer Valves have a flat faced, serrated gasket surface and are supplied to match ASME class 150, 300, or 600 flanges.

This plugging fitting is a consumable component specifically designed for suspended type line stopping operations. It is welded onto the pipeline section that requires isolation, providing a fixed support for the installation of hot tapping and line stopping equipment. The fitting is equipped with an internal O-ring seal, and during the stopping process, it is secured in place by lock pins or locking blocks.

This split cross fitting is a consumable component specifically designed for cylinder type line stopping operations. It is welded onto the pipeline section that requires isolation, providing a fixed support for the installation of hot tapping and line stopping equipment. The fitting is equipped with an internal O-ring seal, and during the stopping process, it is secured in place by lock pins or locking blocks.